Hello all!
I have a Behringer X-touch control surface set for Reaper un Mackie MCU mode.
Works just fine...
This control surface has 3 'controller' inputs for damper, pedals etc...
I would like to to use the #1 FS as a 'record' or 'punch-in" or punch out button.
I found that the FS sends a note ON/OFF value of 0, when released, or 127 when pressed and the note value is C#6.
I am at the point where I just don't know where to look to assign this midi message to the proper 'action', which ideally should be like when I simply press the 'record' button.
I did RTFM, I've checked Ken Gioia videos, I am sure I am almost there, but there is something that evades me...
Any help?
Luc