Digi 003 console

[chuto]

Hi, has anyone managed to connect a digidesign 003 console to Reaper as a control surface and audio interface. Have got audio working fine but have been trying to use CSI to get up and running as a surface but got as far as making reaper crash then having to reboot with factory settings to make it open again. Also the ins and outs disappear from the audio. Just moving over from pro tools so would like to keep the hardware if pos.

[Never]

Originally Posted by chuto

Hi, has anyone managed to connect a digidesign 003 console to Reaper as a control surface and audio interface. Have got audio working fine but have been trying to use CSI to get up and running as a surface but got as far as making reaper crash then having to reboot with factory settings to make it open again. Also the ins and outs disappear from the audio. Just moving over from pro tools so would like to keep the hardware if pos.

Have you tried switching it to
mackie control mode...should
give you pretty much everything you need..I had an
002 and it worked.

[chuto]

Originally Posted by Never

Have you tried switching it to
mackie control mode...should
give you pretty much everything you need..I had an
002 and it worked.

Thanks for your response.
Didn't know you could switch it to MC, can't find it in the manual will do a bit more searching.

[concaocao]

Hi Chuto

I have just purchased an old DIGI003, could you please advise:
- What driver (for WINDOWS 10 64bit) is required to get audio in/out of REAPER
- What settings to use as Control Surface

Thanks in advance