Mackie MCU Pro

[randrohe]

Hello all,
I just purchased the Mackie. I have been using a BCF2000, and that works pretty well.
My question is, can I use the 2 at the same time?
I have the BCF in the live room, and the Mackie in the control room.
Basically, I want a mirror image so they both behave the same on the same channels simultaneously.
Trying to get this sorted out before my return window closes for the Mackie.
Thank in advance

[rothchild]

You might want to check: https://forum.cockos.com/showthread....59#post1988959

I've not tried it myself yet but it claims to support multiple interfaces at a time.

[randrohe]

Thanks for the response. I returned the Mackie MCU Pro as I only had 7 days to check out, and it was working well, but arrived damaged. Now, after hooking my bcf2000 back up, I am having some glitching.
It responds sluggishly and acts a bit odd.
in prefs>control surfaces>add, I have several instances showing bcf2000 dev 5,4.
Also, several instances of Mackie MCU Pro dev 5,4.
I am thinking that reaper isn’t correctly seeing the change back to the bcf?
Should there be multiple instances the bcf and the mcu under add control surfaces?
I can’t imagine anyone actually understand ing this question..
Is there a way to “clear out” control surfaces instances so it just focuses on the current bcf attached and forgets the others?
Man, I should just buy a radar unit.........
Ok, thanks for any input

[randrohe]

Just to keep my thread rolling with observations, I am now finding Reaper to be acting oddly and sluggish.
I’m getting the spinning beach ball with asic commands.
Any connection at all that any one may see?
I’m thinking of uninstalling and downloading reaper again.
Any thoughts at all?

[randrohe]

Since it may help someone else, I’ll post my outcome.
I got the bcf2000 working fine again by deleting all the extra install instances under add control surface.
Also, deleted all instances of the Mackie mcu.