using uTrack24 as interface
New to Reaper. I'm attempting to use the uTrack24 as an interface with Reaper, and it's driving me crazy.
Reaper preferences device set to uTrack24. I insert 24 new tracks. Line in input:mono to each track (track 1-line input mono 1, track 2-line input mono 2, etc). I just leave all of the output routing in default, and this is what happens monitoring through the uTrack24 headphone amp:
track1 audio is panned left
track2 audio is center
track3 audio is panned right
track4 audio is center
track5 audio is panned left
track6 audio is panned right
track7 audio is center
track8 audio is panned left
track9-15 no audible audio (but it shows in the corresponding track led/vu)
track16 audio is center with stereo chorus sound
track17-24 no audio (but is shows in the corresponding track led/vu)
For tracks 9-15, and 17-24 the only way I can get audio to the stereo master buss is to click the monitor input until it shows a speaker icon, BUT, all of those tracks has what sounds like a stereo chorus on them.
Note: track 1-8 nothing is selected as the monitor input.
How can all these tracks be so different when all I did was insert 24 identical tracks, and all I changed was the Line In on each track. Is Reaper just not compatible with the uTrack24? (Mac 10.8)
Last edited by davernoise; 12-08-2018 at 10:20 AM.
|