Quote:
Originally Posted by sickamorz
No longer have the exact code.
It was MCP.io with an edge attachment of 0101
The MCP ext mixer was using edge attachment of 0000
When I would pull the mid position down the bottom cell would report sends rather than insert like it should after removing the 0101 attachment the problem no longer existed.
|
Did you get it figured out?
If not,
0 1 0 1 means the top edge is attached to the bottom and the bottom edge is attached to the bottom.
This should lock the Extmixer in place. When you pull down it will be covered.
if you use
0 0 0 0 it will lock the size, but the entire Extmixer area will slide up and down with the changes in track height.
I believed what you want is
0 0 0 1
this gives you the top edge attached to the top and the bottom edge attached to the bottom.
The Extmixer bottom will stay in the same location, but the top edge of the Extmixer will slide up and down and the Extmixer area will get larger or smaller as you raise or lower the track height.
.