uneven envelope points

[jazzbat]

Can anybody tell me how to even out two envelope points so they are exactly the same number? Some of my envelope points go from -4dB at the start of a phrase and then go to -4.1dB at the end of a phrase. Not to seem too OCD, but that's a little annoying. Because we're only talking about .1dB, I can't seem to get Reaper to drag one of the points either up or down by .1dB to even the line out.

[valy]

Right-click the point and enter the Value?

[valy]

There's also the actions:

SWS/BR: Set selected envelope points to next point's value
SWS/BR: Set selected envelope points to previous point's value

etc.

[jazzbat]

Originally Posted by valy

There's also the actions:

SWS/BR: Set selected envelope points to next point's value
SWS/BR: Set selected envelope points to previous point's value

etc.

Thank you. This is a very friendly forum. While I have you here, when I have an envelope selected, is there a way to select the next envelope point to the right or left of the selected point? That is, is there a way to select it without clicking out of the current point? In Cubase, I would just click the left or right arrow.

[valy]

SWS/BR: Select next envelope point
SWS/BR: Select previous envelope point


There are lots of actions for envelope points, just search the Actions list for "envelope point" and check them out if you have time.

Edit: Ahh, I just read your question more closely. You want to select both points.

[valy]

What about these:

SWS/BR: Expand envelope point selection to the left
SWS/BR: Expand envelope point selection to the right

[jazzbat]

Thank you. You're awesome Valy