Signal not going through FX monitoring unless master hardware output is 1/2

[colonel_claypool]

Hello,

I was wondering why every signal that is routed through the master track is not going through the FX monitoring section if a hardware output other than 1/2 is chosen.

I`ve attached a screenshot to illustrate this. It shows that with 1/2 it?s working as expected. However, when hwardware output 3/4 is chosen no signal will go to the analyzer I have on the FX monitoring chain.

Any idea if this can be fixed?

Thanks in advance for your help.

[Bri1]

I`ve attached a screenshot to illustrate this. It shows that with 1/2 it?s working as expected. However, when hwardware output 3/4 is chosen no signal will go to the analyzer I have on the FX monitoring chain.

Any idea if this can be fixed?

Ulloallo- simplez fix- just change the input pins to 3/4 on your monitoring fx-- (although there is discrepancies there atmo with some plugs. )
If your using media browser and have no selected track-sound will just default to 1/2 output.Other programmes do this >passing through< to default audio route.

[colonel_claypool]

Originally Posted by Bri1

Ulloallo- simplez fix- just change the input pins to 3/4 on your monitoring fx-- (although there is discrepancies there atmo with some plugs. )
If your using media browser and have no selected track-sound will just default to 1/2 output.Other programmes do this >passing through< to default audio route.

Great, that was exactly what I needed.
Thanks for your help.