How to edit the MCU for the X Touch

[Mishkacat]

Had a lot of problems getting the Jogwheel to work with the CSI and Behringer.mst file so been using the Mackie (MCU) option until I can figure it out.

My question is - is there a file that can be edited to map buttons to functions in the same way that the .mst file can be used.

I have looked everywhere but the doesn't seem to be one that holds the mapping settings that can be edited.

Have I missed something or is this not possible and the settings are hard coded into a dll.

Just to clarify I am selecting the "Mackie Control Universal" option under Control surface Mode.

Hoping to go back to CSI if I can get things to work properly, but I would like to try this option for now. Thanks.

Dave