Cockos Incorporated Forums - View Single Post

airon · 08-26-2006, 02:59 PM

No need to reinvent the wheel.

I suggest you take a look at the manual of Protools HD 7.2 available at the Digidesign website. Look up automation and see what people are using a LOT. No Nuendo does not do this, but Reaper may. It can address a Mackie Control Universal, so it might as well take advantage of its faders for fx parameters, AUX sends and Pans as well.

Automation modes like that'll push the value of Reaper by leaps and bounds.

VCA groups would be nice too. Much better than bussing your signals.

Before some of you answer, do take 10 minutes to read the relevant manual entry. Protools is the only critter on the block with this stuff.

08-26-2006, 02:59 PM	#2
airon Human being with feelings Join Date: Aug 2006 Location: Berlin Posts: 11,818	No need to reinvent the wheel. I suggest you take a look at the manual of Protools HD 7.2 available at the Digidesign website. Look up automation and see what people are using a LOT. No Nuendo does not do this, but Reaper may. It can address a Mackie Control Universal, so it might as well take advantage of its faders for fx parameters, AUX sends and Pans as well. Automation modes like that'll push the value of Reaper by leaps and bounds. VCA groups would be nice too. Much better than bussing your signals. Before some of you answer, do take 10 minutes to read the relevant manual entry. Protools is the only critter on the block with this stuff.