View Single Post
Old 09-14-2020, 11:06 AM   #421
MisterGTR
Human being with feelings
 
Join Date: Dec 2017
Posts: 42
Default

Something i came across while trying to get -1dbtp.

My interface is set at 96lhz. And normally i do my projects at 48khz. But after finishing my mix i set the project setting to 192khz and rendered (with the use project rate for FX set) to try and get the limiters to over-sample and thus avoid the inter-sample peaks getting through (this is my probably wrong very basic knowledge at work). It was better but didn't work like TDR's limiter. Hey ho...no big deal as -1dbfs is cool.

However something that did happen which i didn't pick up until after i had submitted was that one or more of the reverbs (most likely altantis) got louder in the mix because i had used a higher sample rate.

Another lesson learned....check the mix before you send it!
MisterGTR is offline   Reply With Quote