Thanks for your response Michael,
Quote:
Originally Posted by mschnell
IMHO it's not a good idea to set the device to such toggle mode. This is very likely confusing to CSI and not supported by CSI.
|
This is the default mode for these buttons, but I'll research to see if I can change them. This controller has spent its whole life in Mackie mode, I've only switched it out today as I've been exploring CSI.
Out of interest though, why is it confusing to CSI?
Quote:
Originally Posted by mschnell
(7f on press, 0 on release (alternative (d) in your other message, if this is the options to configure the firmware of the device)
|
No, these were the options I could think of for responding to it in CSI.