View Single Post
Old 10-22-2020, 02:05 AM   #10634
Geoff Waddington
Human being with feelings
 
Geoff Waddington's Avatar
 
Join Date: Mar 2009
Location: Dartmouth, Nova Scotia
Posts: 11,183
Default

Quote:
Originally Posted by RobinGShore View Post
If I start writing automation, then release the fader/knob to stop writing
Does the fader jump to the correct position when you release it ?

Quote:

  • If I move a control on a track that's in read automation mode the fader/knob values don't snap back like they should when I let go. It doesn't actually write any automation in Reaper (which is correct, it shouldn't) but since the fader doesn't snap back this mean that if I switch the track into another mode and then try to write some automation, it will start writing at the wrong value
  • If I write send automation in touch mode, the send envelope stays latched after I release it.
  • I can't change automation modes from Eucon. If I hit the eucon button for switching modes I can see the eucon mode indicator changing, but it doesn't actually change the mode in reaper. Same thing going the other way, if I switch modes in reaper, it doesn't update the automation status in eucon. I swear this was working in an earlier build.
Will check into the first two.

The third one is definitely not implemented yet, it's on the list, and yes it did work before the re-arch.
__________________
To install you need the CSI Software and Support Files
For installation instructions and documentation see the Wiki
Donate -- via PayPal to waddingtongeoff@gmail.com
Geoff Waddington is offline   Reply With Quote