I am probably being thick as usual
I believe I've sent the sysex to the BCR. Couldn't figure out how to do it in BC Man so sent the .syx via midi ox. No response from the BCR during send.
I am pretty sure I followed installation right. I've added the BCR to the Green page and am monitoring midi in+out. I removed all the other surfaces.
Moving the controls on the BCR results in messages like this:
IN -> bcr b2 47 6f
IN -> bcr b2 47 6e
in the monitor.
But the mappings described in the notes don't seem active.
Thanks
|