Something i came across while trying to get -1dbtp.
My interface is set at 96lhz. And normally i do my projects at 48khz. But after finishing my mix i set the project setting to 192khz and rendered (with the use project rate for FX set) to try and get the limiters to over-sample and thus avoid the inter-sample peaks getting through (this is my probably wrong very basic knowledge at work). It was better but didn't work like TDR's limiter. Hey ho...no big deal as -1dbfs is cool.
However something that did happen which i didn't pick up until after i had submitted was that one or more of the reverbs (most likely altantis) got louder in the mix because i had used a higher sample rate.
Another lesson learned....check the mix before you send it!
|