View Single Post
Old 04-15-2008, 03:14 PM   #39
norbury brook
Human being with feelings
 
norbury brook's Avatar
 
Join Date: Mar 2007
Location: London UK
Posts: 1,979
Default

*I* here you go


Hidden modes and calibration

After installing Houston there is one important thing that you must do. Houston's faders are touch sensitive and the calibration of the touch sensitivity in important for correct operation.

Switch Houston OFF and hold down the 'SEND MASTERS' and 'EQ1' buttons.
Now Turn Houston ON and release the buttons - the unit will now perform its position and touch sensitivity calibration on all faders.
While this is in progress DO NOT touch the faders or the calibration results will be wrong. It is also a good idea to stand well back, while the faders are calibrated. It may sound dramatic, but does give the best results.

Once calibrated the unit retains these values, and this process only need be performed if the Houston is moved to a new environment, or there is a huge change is air humidity where the Houston is used. For instance, you should perform this calibration again if the table the Houston sits on is changed from a metal to a wooden one.

There is another 'soak test' which is available by holding down 'Send Masters' and 'FX Send 1' while powering up; this does a long test, whose function I'm not sure of, but it does give a chance to check all the LEDs are working properly on the unit. Finally, pressing 'Send Masters' and 'EQs' gives a mode which allows the readings from the soak test to be read, particularly the amount of time that was taken (shown in the top left corner).

Switch Houston OFF and hold down the 'SEND MASTERS' and 'EQ2'
Another test mode

Hidden Commands

press <shift> + <motors> ...

now you're able to controll the panorama with the faders.
it works also with <shift> + <motors> while the "fx send X" is activated
then you can control the Aux-Sends with your Faders. (It's really good for making Submixes for e.g. the singer).

Or <Shift> + <motors> while "inserts" is selected, then you can control the insert-FX parameters of the selectet channel with the faders...

"Shift"+"Undo" - "Edit", "History"
"Shift"+"Save" - "File", "Save New Version"
"Shift"+"Motors" - Fader/Encoder flip
"Shift"+"Bank Left" - one Channel Shift Left
"Shift"+"Bank Right" - one Channel Shift Right
"Shift"+"Rewind" - "Transport", "Return to Zero"
"Shift"+"Forward" - "Transport", "Goto End"
"Shift"+"Play" - Cycle on/off

cheers


Marcus
norbury brook is offline   Reply With Quote