Quote:
Originally Posted by pane.valentin
So unfortunately I found no way to cycle banks of faders.
No support from A&H because the console is out of date (no surprise there). Not even the SDK which is based on what I understand on an open source software (no surprise there either).
It's not a bad thing however. I have found ways to overcome this limitation by changing the workflow.
On 24 or less I route each channel to the console and if something else comes up I just buss it into a stereo channel.
When I have more than 24 tracks, I just send Folders to the console. and mix in the box.
Either way, the analog summing is doing it's job.
|
Just in case you haven't seen these:
"Power the console on whilst holding down the PLAY transport button. Release then press Solo/Select switch 1. This sets the GS-R24 into MIDI mode 1."
https://www.allen-heath.com/media/AP...+GS-R24_UG.pdf
I'd play around with the midi modes and see what you get in a midi monitor.
The manual says 2 midi modes, but there have been more added -- is your firmware the latest they released ?
CSI -- the Control Surface Integrator project -- see sig below -- can probably get something workable...