Quote:
Originally Posted by TonE
Yes, I can use also OSC, IF it is sure that it can be done via OSC, with or without feedback, I do not care, as my midi controller has no elements for visualizing this feedback data like LEDs or a display.
|
Here you go (click to download Pd toggle example patch):
Set up with MIDI CC#65 to toggle FX bypass state for focused effect.
If you use e.g. MIDI CC#1, change [ctlin 65 1] to [ctlin 1 1]
(the last 1 selects the input port, and can also be left out to listen to all enabled input ports).
If your controller sends e.g. a value of 1 when clicked, change the [select 127] to [select 1].
Set up a OSC config in REAPER including the following line (it is also in the default config file):
Code:
FOCUSED_FX_BYPASS_TOGGLE /focfx/bypasstoggle
Set up the remote control config in REAPER to send messages to Pd (as in examples above), select MIDI input port(s) in Pure data, and you should be good to go.
There's also a simple OSC monitor (just to see what REAPER can do, no OSC messages from REAPER required) and MIDI CC# monitor (to verify you have incoming MIDI CC#) for convenience.
Quote:
Originally Posted by TonE
Regarding the relative mode, there are already three versions in Reaper, but did you try if any of those does what I want? Any manual about those relative modes does not exist anyway.
|
Did
you try?
I'd figure they are not specific to REAPER, and should be documented well enough elsewhere.