Quote:
Originally Posted by MalcolmG
I think this one got lost in the great Shift Shift discussion 
Anyone seen a widget behave like this? |
Did you try this ?
2.9 Calibrating expression pedals A and B
Should you experience problems with exact MIDI controller data transmission while using the expression pedals, we recommend calibrating the pedals. Calibrating the pedals follows the complition of the FCB1010 self-test.
◊ All software versions 1.4 and newer allow for direct calibration by keeping the switches 1 and 5 pressed while powering up the unit.
If your FCB1010 features the software version 1.4 or higher, skip the first 4 steps in the set of instructions that follow (i.e. start at point number 5). To find if your unit features version 1.4 or higher of the software, first try keeping the switches 1 and 5 pressed while powering up the unit. If nothing happens, start calibrating your FCB1010 beginning with the first step in the list that follows.
• Keep the switches 1 and 3 pressed while powering up the unit. This puts your FCB1010 into self-test mode, and all LEDs are being tested.
• Please wait until all switch LEDs light up. Then press all the switches, including the UP/ENTER and DOWN/ESCAPE keys, so that all LEDs are turned off.
• Wait for a moment while the relay test is completed (four quiet cliking sounds are heard). The display shows F1 if no MIDI connection is present. If you connected MIDI Out to MIDI In, the display shows A1. In this case, the MIDI connections operate correctly.
• Press DOWN/ESCAPE once.
• Move the expression pedal A to the lowest value possible (pedal open). The VALUE 1 LED lights up. When the value is adjusted, press the UP/ENTER key.
• Move the expression pedal A to the highest value possible (pressed down all the way). The VALUE 2 LED lights up. When the value is adjusted, press the UP/ENTER key.
• Move the expression pedal B to the lowest value possible. When the value is adjusted, press the UP/ENTER key.
• Move the expression pedal B to the highest value possible. When the value is adjusted, press the UP/ENTER key.
Both pedals are now correctly calibrated.