View Single Post
Old 06-18-2021, 07:28 PM   #1314
cjewellstudios
Human being with feelings
 
Join Date: Sep 2017
Posts: 998
Default

Quote:
Originally Posted by Funkybot View Post
I've been using it for a few days now without issue. Nothing fancy, just basically took my existing FX Twister template, brought it in, resized some stuff. The connections all work though.

I'd run through all the basics of:

1. Double check your .zon folder
2. Double check the IP addresses (Host and Local IP for device)
3. Double check the ports (particularly if it's sending messages but not getting them - that indicates port problem)
4. Restart Reaper (in my experience, OSC connection changes require a restart - I never got it to just connect following IP changes with a refresh all surfaces)
5. If it's still not working, pop open the CSI Monitor Input from Surfaces action and see what's talking to what
Thanks, as usual, for the methodical approach

Still not getting anywhere. What's super strange is I can open up mk1 and have two way communication and then open up mk2 (after closing mk1) and only get feedback, no control. Same IP address and port info. UDP enabled. I do believe everything is correct after triple checking. CSI monitor confirms what I'm seeing. No input from the surface at all and all the feedback is going out.

I emailed Hexler back just to see if he had any ideas.
cjewellstudios is offline   Reply With Quote